viscosity ratio

The ratio between the continuous phase and the dispersed phase has a strong influence on the viscosity.

连续相与分散相的比率对其粘滞性有着很强的影响。

A Further Study on Choosing Gear Lubricant Viscosity Based on Film Thickness Ratio

基于膜厚比选用齿轮润滑油粘度的再研究

Studied the influence of the TSF/ CS blending ratio on the spinning solution's viscosity, conductivity and fiber morphology.

研究了TSF/CS共混比对纺丝液黏度、电导率和纤维形貌的影响。

The greater the viscosity ratio, the higher the impact strength.

粘度比越大，冲击强度相对较高；

The melting point of three block copolymers was measured with microscope as 232, 248 and 260 ℃, respectively. The intrinsic viscosity of the block copolymer with soft-and-hard segment ratio of 7/ 3 was measured as 1.12 dL/ g with a Ubbelohde viscometer.

利用显微熔点仪、乌式粘度计测定了共聚物的熔点和特性粘数，3种共聚物熔点分别为232248260℃，软／硬段比例为7／3的共聚物的特性粘数为1.12dL／g。

In the thesis, the effect of degradation was characterized by ratio of dynamic viscosity and intrinsic.

本文以动力粘度作为黄原胶降解衡量指标, 同时用特征粘度来表征降解效果.

The change regularity of slag viscosity with Fe/ SiO2 ratio;

炉渣粘度随Fe／SiO2比值变化的规律；

The effect of viscosity ratio on the tensile characteristics, flexural property, impact property and heat deformation temperature of PP/ HDPE were investigated.

研究了粘度比对聚丙烯（PP）/高密度聚乙烯（HDPE）共混物的拉伸性能、弯曲性能、冲击性能以及热变形温度的影响。

Dynamic viscosity ratio at 70 ℃ is sensitive in long term aging, which can be used to characterize the anti-aging performance of the two asphalts in long term aging.

70℃动力粘度比对长期老化敏感，可以表征两种沥青的抗长期老化性能的优劣。

However, The NK cell activity, the CD4 positive T lymphocytes and the ratio of CD4/ CD8 in the control group were decreased significantly. The concentration of slL-2R were decreased and the whole blood viscosity in the control group were not changed.

单纯化疗组化疗后患者NK细胞活性、CD4阳性T细胞数和CD4/CD8比值下降，血清sIL-2R的浓度升高而全血粘度无明显改变。

As the viscosity ratio κ increases, the terminal velocity increases.

随着粘性比κ的增加，液滴速度增大。

Influence of temperature and reaction period to viscosity of lithium silicate is studied. Influence of module of lithium silicate, ratio of lithium silicate to sodium silicate and other factors to film performance are discussed.

考察了反应温度和反应时间对硅酸锂黏度的影响，讨论了硅酸锂的模数、硅酸锂/硅酸钠的质量比等因素对涂膜性能的影响。

The photosensitivity, alkaline solubility and viscosity of products increased as the ratio of maleic anhydride increased.

产物的光敏性 、 碱溶性和粘度随着酸酐配比的增加而增大.